Other users encountered issues when trying to clone an M.2 SSD, with an error message “ Locking drive C:” leaving it stuck in the ready state. It will boot the system outside of Windows and allow Acronis to clone the hidden partitions. To avoid this problem, you can create a bootable rescue media. The real reason is Acronis cannot clone some hidden partitions under normal conditions. There is another situation that can cause the Acronis True Image cloning process to stop at 80%-95%. It is recommended to put the new drive in the laptop first, and connect the old drive via USB. Cloning a hard drive in the laptop to an externally connected drive may cause the system to not work properly, so it is not recommended. This situation often happens when you plan to clone a hard drive on your laptop. Such as stuck on “Calculating time remaining”, “ Less than 1 minute”, etc. The following are some of the common problems collected in the forum and the solutions given by professionals: Read on if you are interested! How to Fix Acronis True Image Cloning ProblemsĪs in the cases above, users often meet that Acronis clone stuck processing. This article will introduce the possible causes of this problem and the corresponding solutions. Above is the problem that users encounter when Acronis True Image hangs during cloning. However, sometimes users encounter some problems while using the software. As a powerful disk imaging software, you can use Acronis True Image to clone to SSD and other drives. Help! Acronis True Image Hangs When CloningĪcronis True Image is a software product produced by Acronis that provides data protection for personal users, its functions include backup, archive, access and recovery. 3 Clone Disks Smoothly with Acronis True Image Alternative. Turn off the Secure Boot Option When Acronis True Image Restart Is Required Create a Bootable Rescue Media When Acronis True Image Hangs 2 How to Fix Acronis True Image Cloning Problems.1 Help! Acronis True Image Hangs When Cloning.If you are still experiencing problems, please contact us for more assistance. You can follow the steps in this article to initialize the new disk, then restart the cloning process. If the SSD is not detected in Disk Management, try another USB or SATA port on the system, or another cable if available to check the connection. Although Acronis should initialize the drive as part of the cloning process, this may need to be done manually in Windows® Disk Management before it will show as a usable drive.If you are running Acronis within Windows, create bootable media and run Acronis from that to rule out other program conflicts.If using USB on a desktop, try different ports on the rear of the system, instead of just front ports. Check another storage device, or USB device, in the port you are connecting the SSD to, to verify it is working normally, or try the SSD connected to a different port.If available, try different cables to rule out a faulty connection.In a desktop, verify that both the power and SATA interface cable are connected firmly and in good condition. Verify all cables are connected securely at each end, and free from damage.There are a few things to check which can resolve this behavior. You may receive an error message after selecting it, or the SSD is not detected and Acronis does not launch, returning a message "This product edition requires at least one Crucial SSD be installed in your system". In rare cases, while selecting the source and destination (target) drives in the Acronis True Image for Crucial® software, the SSD will not show up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |